Thingiverse
Cute Jack-O-Lantern Pumpkin
by lopsidedflan
1.9k
Downloads
2.7k
Likes
18
Makes
I wanted to print a cute jack-o-lantern but couldn't find any, so I made my own version!
The short version is the original height from the Makies model, and I made a taller one in addition.
Both lid versions work with both the short and tall jack-o-lanterns, and there was no problem adding a tealight inside either pumpkin with the lid on. They've also been modified very slightly to be a bit plumper.
The snug lid version snaps onto the pumpkin. It's just tight enough that initially when you try the lid on, it'll seem like it's too tight and would stay stuck. But if you keep taking the lid on and off a few times, it somewhat loosens and the tightness becomes just snug enough to stay locked onto the pumpkin, but doesn't feel too tight to remove. I also included a version where the lid just sits on top of the pumpkin.
Edit 2023.10.13: @wolfchris21 mentioned that the snug lid was too snug for them, so I added a version that is just slightly less snug (stem will still fit). If an
The short version is the original height from the Makies model, and I made a taller one in addition.
Both lid versions work with both the short and tall jack-o-lanterns, and there was no problem adding a tealight inside either pumpkin with the lid on. They've also been modified very slightly to be a bit plumper.
The snug lid version snaps onto the pumpkin. It's just tight enough that initially when you try the lid on, it'll seem like it's too tight and would stay stuck. But if you keep taking the lid on and off a few times, it somewhat loosens and the tightness becomes just snug enough to stay locked onto the pumpkin, but doesn't feel too tight to remove. I also included a version where the lid just sits on top of the pumpkin.
Edit 2023.10.13: @wolfchris21 mentioned that the snug lid was too snug for them, so I added a version that is just slightly less snug (stem will still fit). If an
lopsidedflan also publishes on
3 additional models across 1 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
