Thingiverse
Cute Shelf Bracket
by Tryel
1.6k
Downloads
1.4k
Likes
8
Makes
A basic shelf bracket I made because the ones I got from Ikea were large and ugly, and I needed a project to start to learn Fusion 360 on! These are made to be quick to print, and need no supports or anything, just mirror them for symmetry.
The should be relatively stable, but I haven't done any testing for failure point, and I use them in a very low stress application.
Wood part is an Ikea Ekby, but only because I was to lazy to go to the hardware store and stain/sand some panels myself. Screw holes are parametric, and should be able to be changed. The rest of the parameters don't work so well because this was my first time modelling in Fusion.
Fusion 360 link:
http://a360.co/2jo7nRw
The should be relatively stable, but I haven't done any testing for failure point, and I use them in a very low stress application.
Wood part is an Ikea Ekby, but only because I was to lazy to go to the hardware store and stain/sand some panels myself. Screw holes are parametric, and should be able to be changed. The rest of the parameters don't work so well because this was my first time modelling in Fusion.
Fusion 360 link:
http://a360.co/2jo7nRw
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
