Thingiverse
Cutlery Drainer
14
Downloads
34
Likes
0
Makes
Designed in Tinkercad from scratch. I just wanted something a specific size for my kitchen sink. Sturdy enough not to topple over, durable, easy to clean and also drain well.
I came up with this, and I've been using it since xmas. It does the job just perfectly.
There are two STLs.
One STL of the main body, and the other STL are feet and a mid section bridge support.
Simply superglue each of the four corners on the main body base, and glue the stick support right across the middle of the base. Done
Dimensions are 82mm Width, 185mm Long x 143mm High (with the glued on feet)
Feedback much appreciated.
I came up with this, and I've been using it since xmas. It does the job just perfectly.
There are two STLs.
One STL of the main body, and the other STL are feet and a mid section bridge support.
Simply superglue each of the four corners on the main body base, and glue the stick support right across the middle of the base. Done
Dimensions are 82mm Width, 185mm Long x 143mm High (with the glued on feet)
Feedback much appreciated.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
