Thingiverse
cw keyer (without hardware requirements)
von 3dste
44
Downloads
29
Likes
1
Makes
Yet another cw keyer? Yes!!..
Tiny and lightweight I use it with my FT-817 during QRP excursions.
But this will not require any further hardware than n. 2 M3x6 screws,
some cm of 1mm dia. silver plated (or normal) copper wire and a spring
from a retractable ball point pen.
it is composed by 3 pcs that are assembled by interlocking.
The only thing that requires a little manual skill (but if you are here it means that you have it) is the realization of the contacts using the copper wire. See the pictures.
No glue nor screws
Just print and assemble.
Happy CW!
Tiny and lightweight I use it with my FT-817 during QRP excursions.
But this will not require any further hardware than n. 2 M3x6 screws,
some cm of 1mm dia. silver plated (or normal) copper wire and a spring
from a retractable ball point pen.
it is composed by 3 pcs that are assembled by interlocking.
The only thing that requires a little manual skill (but if you are here it means that you have it) is the realization of the contacts using the copper wire. See the pictures.
No glue nor screws
Just print and assemble.
Happy CW!
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!