Slicer Discord
CX-5 Phone Mount – 3D-printbaar model van MakerWorld MakerWorld
Vehicles

CX-5 Phone Mount

21 Downloads
8 Likes
9 Makes
Model downloaden
Have a Mazda CX-5 and nowhere to put your phone? You need this!I tried a bunch of different phone mounts, most of them suction somewhere, if you have a CX-5, you know you have very limited options for that kind of mount and none of them are good. Then you have the ones that clip on the vents, they never stay where you put them and are in the way of the vents on those hot summer days. I designed this mount to fit between the trim pieces, out of the way of the vents and sturdy. It also has an integrated charger which you can find pretty much any place you buy your phone chargers but I'll put a link to the one I used. You might have to shave the piece a little but to fit it through the screw hole depending on your tolerances. The easiest way to install it is to pull the trim pieces off, it's a pretty simple process, there's lot of youtube videos about it. I had zero experience with it before I did this, you can do it.Chargerhttps://www.amazon.com/dp/B0BLKJJCBV?ref_=ppx_hzsearc
Categorie
Vehicles
Bron
MakerWorld
Gepubliceerd
Bijgewerkt
Wat je nodig hebt om te printen: Gemiddeld Lage betrouwbaarheid
Eendelig Hardware nodig
Supports 1/3
Montage 0/3
Instellingen 1/3
Bedgrootte 0/3
Nabewerking 1/3
Printer
FDM / FFF
Bestandsformaat
STL
Materiaal
PLA
Nabewerking
Hardware
Software
Cura, PrusaSlicer of vergelijkbaar
Nog geen beoordelingen
Nog geen reacties – wees de eerste!

Vergelijkbare modellen

6 Suggesties
Feed Blog Slicer Kostenrekenmachine Zoeken op afbeelding Indienen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Toevoegen aan collectie