CYBERCERATOPS - Suspended String Lamp

Engineered too late, deployed too few.     Before the Raptoris stalked the megacities and before the Cyberdactyl turned the skies into a social-streamed death zone, there was one project still in development—hidden deep beneath the ruins of Bio-Forge Theta: Cyberatops. Created by Dr. Fox Stone in the waning years of the Contest, Cyberatops was never meant to fly or stalk. It was made to stand. To withstand. A walking barricade of ABS bone and TPU bio-plastics.   This 3D model captures that forgotten force mid-stride, its massive frame caught between biology and brutalist engineering. Every curve tells the story of resistance. Every printed layer echoes a time when holding the line meant more than releasing a half baked product and never fixing it later. Instructions: Assembly   Do not use cold plates or excessive glue, taking the print off may damage the strings. Most models with strings only use a single 0.24 layer high string, I use two. That way, if one fails, the other usually does not. The visual is pretty much the same.   To light it you will need the standard 3AAA RGBW pucks, either from Aliexpress or bambu lab.  Here is a link from a seller I used before, you get 3 pucks for a euro - Search “rgbw pucks aaa” on aliexpress and pick the best deal for you. It shouldnt cost more than a euro each Relatively simple, assemble the two halves using an assembly jig in the profile, it is basically two rings that will fit exactly to the two halves, just make sure you put a paper down so the glue doesn't leak and ruin your table (ask me how I know). There are nubs in the provided bases and it will keep it in place for a desktop stand, but carrying it around without gluing it, is not advised… if you are happy with it and do not wish to reuse the base for my other models, go ahead and glue it. Also, DO NOT change layer size because then the mid air strings may fail. Any issues, let me know.