CYC X6 Controller and Mount V2

The original design for this controller depended on an L shaped bracket to mount. Sadly this bracket is no longer included as a part of the kit, and so the older design is now obsolete. I have made the mount narrower so that the controller press-fits into the space as long as the old style brackets aren't there anymore, meaning the little holes are useless but I left them in place.


Tips for success:
Use PETG
The M6 nuts wont go in, by design. I used a soldering iron to heat them and melt them in place.
6 Perimeter Walls and 2mm or 3mm thick top and bottom for thickness. You can also print with 100% infill which means you can cut/saw/sand it to fit.
print with organic supports with the larger side down
remove the front and back plates, drill 4 small holes using the plate as a stencil, and secure the controller using the original bolts, do the same on the smaller side but only for the 2 lower holes.

P.S. You don't have to use both clamps, you only need to clamp one, but can choose