Cycliq CE mounts

I have made a mounting interface to the Cycliq CE family of lights. My design is similar to other quarter-turn and eight-turn mounts because I prefer to have a twist mount that has some spring built into it instead of just mostly rigid plastic providing a snap action.

There are a few models so far:
1. a ziptie seatpost mount for a Cycliq Fly6 CE. It is designed for a 27.2mm diameter seatpost at 73 degrees.
1. a mount that should fit on a BarFly modular bar mount. This one is untested since I do not have a Fly12 CE, but I believe it uses the same basic mount as the Fly6 CE. Dimensions are for 20mm between M4 bolt holes.
1. alternate puck for 20mm between M3 bolt holes. Also not tested since I do not have a K-Edge mount, so the outside diameter may be completely wrong.
1. ~~a CE to gopro adapter. Not yet built.~~Not recommended- the tabs were not strong enough on my build with mediocre layer adhesion.

These are as yet untested on the road or rougher surfaces. Even if they were,