Cylinder and cube calibration object

If you like my designs, hit the like button and post a picture of your print!

I needed an object to check to make sure everything was still calibrated and test circles as I've been printing ovals. So, I created this. It is a 20mm cube with a 20mm cylinder on top. Created in Tinkercad.

I am using an Anet A8, and at the time of publishing this, I am still printing ovals. I have done the follwing:

Printed and installed:
Top frame braces
filament guide at extruder
drag chains
bed spring bushings to keep bed from shifting
X and Y axis belt tensioners
Front and rear frame braces
Semi circle fan duct
Z axis wobble reducers

Added glass bed
Upgraded belts to fiberglass reinforced
Upgraded bearings to Igus Drylin bearings
Upgraded fans
Added MOSFETs for both extruder and bed
Using Raspberry Pi 3 for Octoprint

I've calibrated using a 20mm cube and now get 20mm on all sides. Somehow can no longer print circles...

I am using this object to verify X and Y are still c