Thingiverse
Cyndaquil
von mdelapa
59
Downloads
39
Likes
0
Makes
Cyndaquil Figurine I designed.
Printed at 0.2mm layer height with 5% infill.
I recommend glueing him to a base, as he is too tail heavy and will not stand upright.
I used a 2"x5"x1/2" piece of wood with some cork that I cut up to use as feet, and then glued him onto the base.
As always, if you enjoy my models, consider supporting me.
Printed at 0.2mm layer height with 5% infill.
I recommend glueing him to a base, as he is too tail heavy and will not stand upright.
I used a 2"x5"x1/2" piece of wood with some cork that I cut up to use as feet, and then glued him onto the base.
As always, if you enjoy my models, consider supporting me.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
