MakerWorld
Board Games
Zum Modell
D&D Box/Roll Tray/Counter
148
Downloads
63
Likes
0
Makes
Introduction:The dice case is fully 3D printed, no supports are needed. You need to glue the D&D letters in and a few letters in the inside and the rollsurface as well. This is a reupload from Thingiverse as I have not been able to find anything like it on here. In addition to this, all parts have been laid out on 4 plates to allow for optimal printing. No supports are needed.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
