D&D NPC Tokens

Non-flat, miniature sized tokens that can be used as a player/monster/npc tokens for tabletop RPGs. Tokens are numbered 0-7 (sorry for programmers counting, zero was easier to design than one). I've used filament swapping at layer height to make these tokens multi-color without much waste. InstructionsModels are placed upside-down on printing bed for filament swapping (check photos). I found it that this orientation also prints cleanerMulti-colourMulti-colour seen in pictures is achieved using layer range modifier.To get different colour for the top of token and the body so number would pop-out nicely add filament-swap at layer height of 0.6mm (for 0.2mm layer height).To get back to top colour (like seen in a picture) switch back to original colour at layer height of 3.8mm.SupportsNo supports are needed. Models are angled 35 degrees which prints fine with no supports. Numbers require some bridging but gaps aren't too big and I had good results with multiple filaments.