Thingiverse
D1 Mini Case
door trutgers
6
Downloads
8
Likes
0
Makes
This is a case for a Wemos D1 Mini board that I designed for use with my D1 Minis that I use for custom LED strips.
The case includes a few small cutouts for the micro-usb cable and 5v, ground, and DIN wires coming off the board respectively. It also includes a small lever/button for the reset button on the D1 mini.
I've printed without supports fine, but the reset button may require them depending on your settings.
The D1 mini should fit snugly in the case with no need for adhesive.
The case includes a few small cutouts for the micro-usb cable and 5v, ground, and DIN wires coming off the board respectively. It also includes a small lever/button for the reset button on the D1 mini.
I've printed without supports fine, but the reset button may require them depending on your settings.
The D1 mini should fit snugly in the case with no need for adhesive.
trutgers publiceert ook op
11 extra modellen op 2 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
