D1 mini Sensor Case - LD2410C, BH1750

I Modified the project to be able to store a LD2410C instead of the temp sensor.Also i opened part of the top case for the light sensor, as the measurements were pretty low. There is plenity of space for the cables, so you should be able to even make it shorter.My cables are a bit too long but it works perfectly The case it's for the ESP32 D1 Mini but if you remove the center square on the top, you can fit a Wemos ESP8266 in there. This is the code on ESPHOME for the Wemos ESP8266 D1 Mini: i2c: sda: GPIO4 scl: GPIO5 scan: false uart: id: uarts tx_pin: GPIO15 rx_pin: GPIO13 baud_rate: 256000 parity: NONE stop_bits: 1 ld2410: timeout: 30s max_move_distance : 6m max_still_distance: 0.75m g0_move_threshold: 50 g0_still_threshold: 20 g1_move_threshold: 50 g1_still_threshold: 20 g2_move_threshold: 40 g2_still_threshold: 40 g3_move_threshold: 40 g3_still_threshold: 40 g4_move_threshold: 40 g4_still_threshold: 40 g5_move_threshold: 40 g5_still_threshold: 40 g6_move_threshold: 30 g6_still_thres