Thingiverse
D1 Wemos case
di jxoco
4
Download
3
Likes
0
Makes
Simple case for ESP8266 wemos D1 mini.
With the micro usb connector.
Just drill holes for temperature or SW420 or flame sensor wires.
Hangs from wall plug.
Uses two 2mm x 8 screws.
Uses a small amount of filament and screws.
As shown in the picture a DS18B20 sensor is attached. I find that if the temp sensor is closer than about 5 inches to the ESP it is affected by the heat of the ESP.
Like my other cases, it hangs from the 5 volt power cube on the AC receptacle;
ESP8266 https://www.thingiverse.com/thing:6532569
D1 mini https://www.thingiverse.com/thing:6546733
ESP8266 with RCWL https://www.thingiverse.com/thing:6544638
D1 mini snap case https://www.thingiverse.com/thing:6547710
With the micro usb connector.
Just drill holes for temperature or SW420 or flame sensor wires.
Hangs from wall plug.
Uses two 2mm x 8 screws.
Uses a small amount of filament and screws.
As shown in the picture a DS18B20 sensor is attached. I find that if the temp sensor is closer than about 5 inches to the ESP it is affected by the heat of the ESP.
Like my other cases, it hangs from the 5 volt power cube on the AC receptacle;
ESP8266 https://www.thingiverse.com/thing:6532569
D1 mini https://www.thingiverse.com/thing:6546733
ESP8266 with RCWL https://www.thingiverse.com/thing:6544638
D1 mini snap case https://www.thingiverse.com/thing:6547710
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
