D20 blossom box

i spent a good while remixing this and it came out pretty good. if you have problems or found a better way to print it shoot it in the comments. you will need to pry the bottom ring free after printing to free the two parts. then you should be able to slide an razor between the flaps to get them apart. after that you will need to free the gears from the sides and slowly work it till it moves freely.

Video with steps on how to free the parts up.
https://www.tiktok.com/t/ZTRW3Xyjo/

Updated 3-9-23
Fixed a cavity under center post that was effecting printing
Thanks to Demongnash for bringing this issue to my attention.