D20 earring

I made a lamp based on this design and wondered if I could figure out how to print it with enough quality to wear as an earring. After many trials and errors I landed on these print settings. You can get a decent looking one without supports if your speed is low enough and plate is tacky enough but I wanted them to look good on close inspection as well as from a distance. TAKE YOUR TIME removing the supports. I used a small pair of needlenose and twisted a small piece off at a time then cleaned up any loose bits with a SHARP deburring tool. I might recommend printing 3 for your first round in the event you mess one up. If you print them and like them please boost me. Thanks!Boost Me