Thingiverse
D20 Keeper
por idle_time
207
Descargas
168
Likes
0
Makes
UPDATE: after some testing I found that .2 to .3 layer height printed the easiest and you may want to print a few at a time to keep the layers from over heating, even with 100% fan I was having issues. Also I would scale up to 108% to 110%. I recently got a resin printer and with 110% the die fit well and had just the slightest wiggle and "rattle".
A D20 keeper cage! Always keep your lucky D20 with you as a keychain or pendant! (Should fit sharp edged dice as well)
Designed to fit a 20mm die. It is a bit difficult to print, but possible. Send it out to get printed in metal or if you have a flexible filament you should be fine I think.
PLA has a bit of flex to begin with so the "hinge" area should withstand a few bends back and forth before failing. I recommend cutting or hole punching out a small circle of flexible material to glue to it, like thin leather or cloth from an old T-shirt or whatever you have lying around, and that will act as the hinge for it.
If possible I
A D20 keeper cage! Always keep your lucky D20 with you as a keychain or pendant! (Should fit sharp edged dice as well)
Designed to fit a 20mm die. It is a bit difficult to print, but possible. Send it out to get printed in metal or if you have a flexible filament you should be fine I think.
PLA has a bit of flex to begin with so the "hinge" area should withstand a few bends back and forth before failing. I recommend cutting or hole punching out a small circle of flexible material to glue to it, like thin leather or cloth from an old T-shirt or whatever you have lying around, and that will act as the hinge for it.
If possible I
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
