Thingiverse
d20 lamp
por Karpus
2
Descargas
4
Likes
0
Makes
d20 lamp!
Basically, you print 18 pieces of d20_part.stl. screw them to each other using M3 x 10mm (you'll need around 60) screws.
The stand is configured to fit this cable from amazon:
https://www.amazon.de/dp/B0967G5RHR?psc=1&ref=ppx_yo2ov_dt_b_product_details
I split it in two for easier printing.
Afterwards, you can upload any picture you like and create a Lithophane for it at:
https://lithophanemaker.com
You will need 18 of those as well. Size should be 95mm on all sides of the triangle.
Enjoy!
P.s.: I can share the Onshape file for it, but it is not cleaned up rn and might be confusing. So let me know if you need it!
Basically, you print 18 pieces of d20_part.stl. screw them to each other using M3 x 10mm (you'll need around 60) screws.
The stand is configured to fit this cable from amazon:
https://www.amazon.de/dp/B0967G5RHR?psc=1&ref=ppx_yo2ov_dt_b_product_details
I split it in two for easier printing.
Afterwards, you can upload any picture you like and create a Lithophane for it at:
https://lithophanemaker.com
You will need 18 of those as well. Size should be 95mm on all sides of the triangle.
Enjoy!
P.s.: I can share the Onshape file for it, but it is not cleaned up rn and might be confusing. So let me know if you need it!
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
