Thingiverse
Da Vinci GoPro Camera mount - Hero 2 Version
door OMSmedia
103
Downloads
61
Likes
3
Makes
Wanted a quick and easy to remove Da Vinci Camera mount for my older Hero 2 Camera. Allows for GoPro BackPak for remote control if needed. Fits inside with door closed.
This is a 'fixed in place' version using the bed clamp from: http://www.thingiverse.com/thing:828083
and the GoPro Hero Frame Case by: http://www.thingiverse.com/thing:213280
Should work with XYZPrinting Da Vinci 1.0/1.0a/2.0
Done with Lightwave 11.6 and DaVinci 1.0a
NOTES: * REMOVE BEFORE CALIBRATION PROCEDURE *
(Also if you downloaded v2 that was the shorter prototype uploaded my mistake..Please use v2-1 to avoid impact during test strip printing)
New Version: PLUS 35 - Should fit without calibration issue
In Action: https://www.youtube.com/watch?v=bfkruL39vlQ
This is a 'fixed in place' version using the bed clamp from: http://www.thingiverse.com/thing:828083
and the GoPro Hero Frame Case by: http://www.thingiverse.com/thing:213280
Should work with XYZPrinting Da Vinci 1.0/1.0a/2.0
Done with Lightwave 11.6 and DaVinci 1.0a
NOTES: * REMOVE BEFORE CALIBRATION PROCEDURE *
(Also if you downloaded v2 that was the shorter prototype uploaded my mistake..Please use v2-1 to avoid impact during test strip printing)
New Version: PLUS 35 - Should fit without calibration issue
In Action: https://www.youtube.com/watch?v=bfkruL39vlQ
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
