Daedric Armor split for smaller printers

This is the same size models but just split for smaller printers (I made mine for my Anet A8, which is about 220mmx220mmx240mm). All the models were split using Blender and I am including those files as well. As soon as I split and print the rest of the files I will add them. Thanks Jace1969 for the wonderful models!

Update 1: Finally perfected the fingers of the armor, split the original into two pieces for each finger and got them to print smoothly, for my fingers at least I had scalings of thumb at 115%, pointer/middle at 110%, ring at 100%, and pinky at 85%

Update 2: I have uploaded the files for the split shoulders and left boot. The shoulder pads are the same on each side so all you need to so is flip the left one for the right, but you cant do that for the full shoulder as one is bigger than the other. The same is true for the boot, I have only uploaded the left boot because all you need to do is flip it to make it the same as the right boot. If needed, please comment that