Thingiverse
DAEMON 3D Printer 150mm Y Axis Extension
por Zinoberrot
2
Descargas
5
Likes
0
Makes
These two files are for an extended Y-axis version of the Daemon 3D printer, increasing the Y travel by 50mm. That's the maximum I managed to get without significantly affecting the quality. You will need a printer with a minimum print surface of 300mm to print these files.
The two files are:
a) an extended version of my previously published reinforced bed
b) an extended version of the printer's base, modified to hold an MKS Gen L board.
I strongly suggest using steel rods for the Z axis, especially if you are increasing the printer's height.
The two files are:
a) an extended version of my previously published reinforced bed
b) an extended version of the printer's base, modified to hold an MKS Gen L board.
I strongly suggest using steel rods for the Z axis, especially if you are increasing the printer's height.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
