Thingiverse
Dampers for noise reduction
von anrheiner
0
Downloads
0
Likes
0
Makes
I was always bothered by the noise from my 3D printer, which carried through my timber-framed house. So I put dampers on the table where the printer sits. The result is absolutely satisfactory.
Print with TPU, Shore 98A (ISO 868 ) with 30% infill.
If your table is very heavy, increase the infill.
Print with TPU, Shore 98A (ISO 868 ) with 30% infill.
If your table is very heavy, increase the infill.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
