Thingiverse
Dan Case A4 V4.1 Side Panels
von Hosjmanne
3
Downloads
8
Likes
0
Makes
I made this panel to print on smaller printers.
Its a design to snap the 2 parts together.
Its a tight fit bit it will work, it could be that you have to file it slightly to make it snap together.
After it snapped together you can use a small little drop of glue to make sure the mech part is sollid connected to each other.
I preffer to glue it on the side that faces into the case.
Now you will have a solid side panel you can screw on to the case.
I prined the 2mm thick panel in PETG and it works perfect!
I included:
- A 2mm and 4mm thick panel you can print on smaller printers (a rear and front piece)
- A 2mm and 4mm thick panel you can print on big printers (the full size panel)
- And only the frame so you can make your own mech if you want.
So feel free to Remix it and let me know what you think of it!
Have fun !!!
Its a design to snap the 2 parts together.
Its a tight fit bit it will work, it could be that you have to file it slightly to make it snap together.
After it snapped together you can use a small little drop of glue to make sure the mech part is sollid connected to each other.
I preffer to glue it on the side that faces into the case.
Now you will have a solid side panel you can screw on to the case.
I prined the 2mm thick panel in PETG and it works perfect!
I included:
- A 2mm and 4mm thick panel you can print on smaller printers (a rear and front piece)
- A 2mm and 4mm thick panel you can print on big printers (the full size panel)
- And only the frame so you can make your own mech if you want.
So feel free to Remix it and let me know what you think of it!
Have fun !!!
Hosjmanne veröffentlicht auch auf
1 zusätzliche Modelle auf 1 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!