Thingiverse
D&D NPC Tokens
por AurochsCross
100
Descargas
57
Likes
0
Makes
Non-flat, miniature sized tokens that can be used as a player/monster/npc tokens for tabletop RPGs. Tokens are numbered 0-7 (sorry for programmers counting, zero was easier to design than one). I've used filament swapping at layer height to make these tokens multi-color to have easily distinguishable sets.
# Instructions
Models are placed upside-down on printing bed for filament swapping (check photos). I found it that this orientation also prints cleaner as the top of
### Multi-colour (by swapping filament)
Multi-colour seen in pictures is achieved using filament swapping. Both .gcode and .3mf files have filament swapping enabled.
To get different colour for the top of token and the body so number would pop-out nicely **add filament-swap at layer height of 0.8mm**.
To get back to top colour (like seen in a picture) **add another filament-swap at layer height of 3.8mm** and swap pack to previous filament when printing.
### Supports
No supports are needed.
M
# Instructions
Models are placed upside-down on printing bed for filament swapping (check photos). I found it that this orientation also prints cleaner as the top of
### Multi-colour (by swapping filament)
Multi-colour seen in pictures is achieved using filament swapping. Both .gcode and .3mf files have filament swapping enabled.
To get different colour for the top of token and the body so number would pop-out nicely **add filament-swap at layer height of 0.8mm**.
To get back to top colour (like seen in a picture) **add another filament-swap at layer height of 3.8mm** and swap pack to previous filament when printing.
### Supports
No supports are needed.
M
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
