Thingiverse
DARKMAX TPU Canopy
4
Downloads
1
Likes
0
Makes
I designed a canopy to fit onto a DARKMAX Airframe for a friend.
The canopy should easily fit a 2 high stack plus a halfwidth VTX like a Unify Pro
There's space in the rear to mount an RX as well as a through hole for the XT60 and an antenna pigtail mount.
The shark-fin has holes in it meant to have a CF rod pushed through them:
https://tinker.life/2020/02/11/carbon-fiber-reinforcing-3d-prints/
Use 25mm standoffs.
The canopy should easily fit a 2 high stack plus a halfwidth VTX like a Unify Pro
There's space in the rear to mount an RX as well as a through hole for the XT60 and an antenna pigtail mount.
The shark-fin has holes in it meant to have a CF rod pushed through them:
https://tinker.life/2020/02/11/carbon-fiber-reinforcing-3d-prints/
Use 25mm standoffs.
TinkerLifeProjects also publishes on
9 additional models across 1 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
