Darth Vader Melted Mask

I had been looking for a a really good Vader Mask and I found a couple but this is my favorite. The model had a few errors and I had the software fix them. I then positioned it a bit better for printing. First I printed a few at a smaller scale and so I suggest scaling down to 70% the first time but thats up to you. One more thing I printed the model in the picture at 70% scale and a 5% infill (15% is suggested) and it was a 13+ hour print so a heads up.

***Update 7-04-2022*** I must say that this requires supports but I've cleaned it up a bit recently and uploaded a 176x134mm model thats been fixed so now if you put supports on the build plate only it should be fine. If need I suggest small spring assisted needle nose pliers as well as a very small flat head screwdriver for getting in the small areas and cracks to remove the supports. The original designer had a hollow version which I may upload later but it is much tougher than this one to get right. With that said hope to see som