Dashboard Holder for Mobile Device(s)

This model is a holder/organizer for your phone and fits into the dashboard of a VW T5 / T5.2 / T6. The thickness of your device should be less than 10mm (including case) to fit into the holder. There are variuos holes in the model where you can run your USB-C cable through (for charging). It organizes the spare cable-length in the middle, so you reduce the mess a bit. Just print the parts (no support needed) and assemble everything. Some M3 Heat-Inserts and 4 M3x10 screws are needed for assembly. Better print the model in PETG or ABS, because in summer it gets very hot under your windscreen. So PLA might not be the best choice. For better adhesion I addes some pieces of a rubber-mat.