Datacorp PROTOTYPE

This is very much a prototype like the name suggest. It's currently being worked on with plans of being tidied up (namely the back left and right legs, and flattening the base plate). Just figured I'd share the STL for those willing to put in a little elbow grease to make it perfect. Pro tip: if you lower it below the build plate the base of the model will even out and print just fine on an FDM printer. This is true at least in Voxelmaker, not sure how other slicers would handle that method.In my build, I custom cut some 2mm acrylic plates with a Dremel and drilled holes for 5 M3 bolts with nuts. Rubber feet were then placed on the acrylic bottom. I also placed rubber backing from the feet sheet between the board and the acrylic plates to act as a gasket.