Davinci 1.0 Spool Holder

Yet another spool holder. This was made for HatchBox filament spools. Or should fit any spool with a 32mm ID and 65mm wide. This requires one bearing that you can easily purchase from Amazon.com the dimension are 42MM OD X 17MM ID X 12MM W. The bearing fits snugly inside the hanger body. The shaft then slides in from the front of the hanger into the bearing and is held in place by the threaded cover. Then slide on one of the cones, the spool, the second cone and then the threaded nut. Also to ensure that the hanger doesn't break I've uploaded a few supports that slide over the sides. A fresh 2lb spool can hang without them but just to be safe. Also I've added a spacer, you will need 2 total.