Dayton KAB-60M Case

Simple and compact case for Dayton KAB-60M amplifier that allows for access to all connections. I created this with the intention of being placed in a larger enclosure with no special mounting considerations. If your use case differs, let me know and I'll see if I can create alternate pieces to accommodate the need.

Instructions:
- must use supports when printing bottom (for countersunk socket head screw holes)
- place top down when printing top (no supports needed)
- place board in bottom piece (should be moderately tight-fitting) and observe that it is flush with the edges of the bottom case
- affix top and bottom pieces with M3x10 socket head screws (I used [these](https://www.mcmaster.com/91292A113/) because that's what I had available, but anywhere between M3x5 - M3x10 would be sufficient)
- top and bottom pieces should be gapless where they meet