DBG K2 Plus Vent V2

This is my version 2 and a complete redesign of my vent, the only similarity to version 1 is that it connects the exhaust fans to a 4-inch (100mm) vent pipe and has magnets.If a connection is needed for other size vent ducts let me know and I will do my best to add them.Some notes on this project:• Designed not use any support (I hate supports)• Parts are screwed together but will hold without screws. • Screws and magnets are used for mounting to the back of K2 and the vent duct, using just the screws will work but might not have a good seal to the back of the K2.• This project has some very large parts so:o Make sure your build plate is level and flat.o Increase the plate temperature by 5 to 10 degrees C for better adhesion and quality.• The CFS buffer needs to be relocated to either the back of this vent or to the back of the CFS. I prefer the back of the CFS but that will be determined by your setup.• The magnets should be held in with a drop of Cyanoacrylates (super glue).• The extra hole in the magnet mount is to make it easier to remove the magnet if ever needed.