MakerWorld
Electronics
Go to Model
Dc Fan Control
78
Downloads
26
Likes
30
Makes
This is my design of a simple case for the 1203bb controller. The case has a cutout for jumper wires that can be glued in place for a 3Pin PC fan connector. I glued the parts in place with ca. 2mm gecko tape. The lid is screwed on with m3 screws.Additional parts: reverse switch (comes with the 1203BB module) 5.5 mm x 2.1 mm DC Power Connector2 x Jumper wire (male)4 x m3 screws (≤16mm long)
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
