Thingiverse
Deadcat FPV MicroQuad 110mm
by DwarfStarFPV
32
Downloads
29
Likes
1
Makes
UPDATE: 2/28/2019 - REVISED FRAME, LESS WEIGHT (4.7g) AND STRONGER DESIGN, ALSO HOLE UP FRONT FOR AIO VTX CAMERAS SUCH AS THE AKK S2
AVAILABLE IN 8.5MM AND 8MM MOTOR MOUNTS
Build Fly Crash, you have more than 9 lives with the Deadcat frame !
Grab a Micro Scisky, KingKong NZ32, F3 FC, pretty much any brushed FC can fit on this frame
8.5mm motors (Comment if you'd like this frame for 10mm motors)
VTX setup, go for the stand alone systems because the AIOs may require some trimming of the frame
50 to 65mm props
250 to 750mah lipo
AND GO HAVE FUN !
Takes about 50 mins to print this frame and top (Use good filament ABS or Nylon)
Go subscribe to my Youtube and follow on Instagram for latest designs and frame giveaways @dwarfstardrones
Don't have a 3d printer? We sell frames, check out the store, link is on my main page.
#flysmall #flydwarfstar
AVAILABLE IN 8.5MM AND 8MM MOTOR MOUNTS
Build Fly Crash, you have more than 9 lives with the Deadcat frame !
Grab a Micro Scisky, KingKong NZ32, F3 FC, pretty much any brushed FC can fit on this frame
8.5mm motors (Comment if you'd like this frame for 10mm motors)
VTX setup, go for the stand alone systems because the AIOs may require some trimming of the frame
50 to 65mm props
250 to 750mah lipo
AND GO HAVE FUN !
Takes about 50 mins to print this frame and top (Use good filament ABS or Nylon)
Go subscribe to my Youtube and follow on Instagram for latest designs and frame giveaways @dwarfstardrones
Don't have a 3d printer? We sell frames, check out the store, link is on my main page.
#flysmall #flydwarfstar
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!