Thingiverse
Deadpool Helmet stand
door bdubil
15
Downloads
72
Likes
0
Makes
Recently printout Deadpool and Wolverine masks and needed a stand. So I put this together.
You will need a 3/4 inch wood dowel cut to your preferred length.
Plaque - has a notch in it so it can be glued on the base at an angle. You can also glut it facing straight up on the base if you like. I paused the print for the color change on mine.
I did use supports on the notch in the plaque.
base-bottom.stl - This doesn't need to be printed unless you are gluing the eyes on like I did. It is only 2mm thick so adjust the Z height in your slicer if you need it thicker.
Wolverine stand can be found here - https://www.thingiverse.com/thing:6783722
You will need a 3/4 inch wood dowel cut to your preferred length.
Plaque - has a notch in it so it can be glued on the base at an angle. You can also glut it facing straight up on the base if you like. I paused the print for the color change on mine.
I did use supports on the notch in the plaque.
base-bottom.stl - This doesn't need to be printed unless you are gluing the eyes on like I did. It is only 2mm thick so adjust the Z height in your slicer if you need it thicker.
Wolverine stand can be found here - https://www.thingiverse.com/thing:6783722
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
