MakerWorld
Signs & Logos
Go to Model
Deadpool Logo Keychain - AMS Not required
122
Downloads
28
Likes
46
Makes
Deadpool Logo Keychain Start with black filamentSwap to Red at Layer 14 (2.8mm)Swap to White at Layer 26 (5.2mm) Make sure you're flushing enough filament when you swap to white – There's only three layers of white so you want to be sure you're getting extruding clean white when you get to the last layer change ----------------If you like my stuff, check out my patreonhttps://www.patreon.com/LilacRage
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
