Thingiverse
Deans Connector Soldering Stand
by idig3d
67
Downloads
37
Likes
0
Makes
After showing a buddy my [Solder Fingers](http://www.thingiverse.com/thing:1684720), he wanted something to hold a Deans connector for soldering So I thought this up, and way over engineered, but a fun little challenge.
The thumbwheels rotate and click in on 90º. You can insert a mating connector and tighten the set screw to hold it so it can hold the connector and act as a bit of a heatsink. Screw holes to mount to bench or snap in a magnet.
Printed best in something more flexible than standard PLA--high-temp PLA, ABS, PETG, or ASA.
Needs:
4 M3x10 screws for dial assembly
2 M3x6 screws for set screws to hold mated connectors
12mmx3mm magnet for base
https://youtu.be/tqZjS9RRJLI
The thumbwheels rotate and click in on 90º. You can insert a mating connector and tighten the set screw to hold it so it can hold the connector and act as a bit of a heatsink. Screw holes to mount to bench or snap in a magnet.
Printed best in something more flexible than standard PLA--high-temp PLA, ABS, PETG, or ASA.
Needs:
4 M3x10 screws for dial assembly
2 M3x6 screws for set screws to hold mated connectors
12mmx3mm magnet for base
https://youtu.be/tqZjS9RRJLI
idig3d also publishes on
6 additional models across 1 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!