Thingiverse
Death Archon Proxy
par TheMindRobber
24
Téléchargements
11
Likes
0
Makes
After seeing the new model for the Death Archon in Warmachine/Hordes, I thought it looked familiar. I looked up the Reaper Form of Death from Darksiders 2, and decided it was close enough. It took me hours of searching, but I finally found a 3D model of it here: https://assetsdownload.com/free-skeleton-death-with-scythe-3d-model/
Anyway, the model is so close that I barely had to change it. I did add some stuff though. I used this skull for the belt: https://www.thingiverse.com/thing:1040192, these ribs for the ribs: https://www.thingiverse.com/thing:4331732, and the wing bits from this model cause I couldn't figure out a good way to do it: https://www.thingiverse.com/thing:1592690. I would add these to the remix section, but that doesn't seem to work anymore. Unfortunately, every time I tried to run it through Netfabb, it would fail to load the mesh, and running it through other fixing programs failed to rectify it, so I'm just uploading it as is, but that means somethings wrong with
Anyway, the model is so close that I barely had to change it. I did add some stuff though. I used this skull for the belt: https://www.thingiverse.com/thing:1040192, these ribs for the ribs: https://www.thingiverse.com/thing:4331732, and the wing bits from this model cause I couldn't figure out a good way to do it: https://www.thingiverse.com/thing:1592690. I would add these to the remix section, but that doesn't seem to work anymore. Unfortunately, every time I tried to run it through Netfabb, it would fail to load the mesh, and running it through other fixing programs failed to rectify it, so I'm just uploading it as is, but that means somethings wrong with
Vous avez imprimé ce modèle ? Connectez-vous et partagez votre make !
Connectez-vous pour laisser un commentaire
Se connecterPas encore de commentaires – soyez le premier !
