Thingiverse
Death Star Planter
by cheesemcgee
3.8k
Downloads
2.8k
Likes
12
Makes
My son wanted to give a Death Star planter to his friend for her birthday, and I had recently printed the design by embeddedjunkie, so i placed all the parts together and sliced off the top. It works perfect for the planter and the bonus is, if you don't use too much infill or layers, it has the ability to leak the excess water out of the bottom if you over-water.
The base is a scaled up version by Geekdad_3D because he built braces for the original stand which should hold the weight better for this remix.
I was in a rush to print for the party, so I did not use supports, and there was only some slight drooping at the first two rings towards the top. The strands were easily removable, but if you have the time, the supports will help out a lot.
The base is a scaled up version by Geekdad_3D because he built braces for the original stand which should hold the weight better for this remix.
I was in a rush to print for the party, so I did not use supports, and there was only some slight drooping at the first two rings towards the top. The strands were easily removable, but if you have the time, the supports will help out a lot.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
