Death Star Wall

Made the panels as large as would fit on my P1S. You'll want to pull the purge line off right after it prints to prevent the panel going over it, at least on the light panels. (it was either that or make all the panels smaller)Clips can be screwed to the wall then slide the panel onto them, but will also hold the panels together fairly well just with friction.For mine, I only put screws in the top and bottom clips and it has held up well. Shorter clips in are there to get started at the top, then insert as you go down with the screw hole down. Light panels have notches for a 5mm led strip. I used Govee H6150. FYI, I have 7 panels on each side and soldering together 2 of the 16.4ft lengths fit perfect. Also has the mount for lightsabers (or whatever). A little large but the match the white insert shape of the light panels.