Thingiverse
Deathclaw 2
von Swift2568
181
Downloads
117
Likes
2
Makes
Last year I remixed a Deathclaw for warmachine. I cut it up into printable chunks, and scaled it down. It took me a week to do, because I was still new. I made a lot of mistakes. One of those prints sits on my desk and every day I look at those mistakes. Yesterday, in a couple hours, using all the things I've learned over a year of 3d printing and model work, I remixed the deathclaw again.
Improvements:
- I decided to utilize 1.75mm PLA for pins instead of trying to plan and model pins into the parts.
- Scaling is better
- fit of parts is better
- Better base design incorporates the texture from the original models base.
- new modeling techniques caused less detail to be lost
This model is scaled for the game Warmachine, but it should be about right for D&D as well.
During assembly I found it very handy to have a small 1.75mm drill bit on hand to clean out the holes. I used CA glue, which I find works very well on PLA. The most difficult part of assembly was figuri
Improvements:
- I decided to utilize 1.75mm PLA for pins instead of trying to plan and model pins into the parts.
- Scaling is better
- fit of parts is better
- Better base design incorporates the texture from the original models base.
- new modeling techniques caused less detail to be lost
This model is scaled for the game Warmachine, but it should be about right for D&D as well.
During assembly I found it very handy to have a small 1.75mm drill bit on hand to clean out the holes. I used CA glue, which I find works very well on PLA. The most difficult part of assembly was figuri
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
