Deauther Monster Case

The Deauther Monster is just a Deauther with a couple of big 3200 mAh LiPo batteries, a flashlight LED, and auxiliary USB ports. Nice emergency/portable USB power source too.

This is just a case for it. I drew this up around the V2. The dimensions may be the same with V1 and V3 but the layout of some important bits appears to have changed a little. So this is for V2.

There are pockets in the bottom for non-skid feet. There is a base and a ring. The Monster just screws into the base using the screws that would have held the bottom plastic shield it came with. Then the ring goes on and the screws hold the top shield which in turn holds the ring in place. You’ll need to drill holes in the top shield for reset and flash button access. I already put an access hole in the ring where part of it would have occluded the reset button. Or just take off the top when you want to update firmware. The on/off button has a bendy arm in the ring with a foot to actuate that. After printing, I had t