DeBurring Glue Stick Station for AMS Riser V2

I keep finding myself holding a build plate in one hand while juggling a worn down glue stick. So I decided to make myself a one handed gluestick station. This mounts to one of the FITS connectors on the side of the AMS Riser V2. Because it entails both pulling down on the glue stick and pushing it back up into its cap, as well as lateral pressure when using its silicone glue stick driver, the available FITS connectors were not rigid enough. I needed one that locked in tight. So this item fits in that connector slot very tight and locks down with no wiggle room.I incorporated storage for all the deburring tools I often use on fresh prints as well. There are sockets on the bottom for two 4mm threaded inserts. You just drill a hole in the cap of your favorite brand of glue stick and screw it to the bottom of the station with a large washer. Use just 1, or both, or use the spare threaded insert for your own purposes.The file shows 2 build plates because I wanted to print the cap to the de