Thingiverse
Deburringtool holder to wall
von Folkke
0
Downloads
2
Likes
0
Makes
Simple holder for deburringtool, inside diameter 12 mm.
Printed first in PLA, but it broke too easy when screwing to the wall, changed PETG and all good. I printed with 0.28 layer.
Will work also as a pencil holder
NOTE! If you're using Temu type of deburring tool, it is littlebit bigger (diameter about 14mm). Then scale this up 25 - 30%, and it should fit
Printed first in PLA, but it broke too easy when screwing to the wall, changed PETG and all good. I printed with 0.28 layer.
Will work also as a pencil holder
NOTE! If you're using Temu type of deburring tool, it is littlebit bigger (diameter about 14mm). Then scale this up 25 - 30%, and it should fit
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
