DECAH v4 HIGHFIDELITY SPEAKER SYSTEM

Due to its strength and versatility, PETG would be the best for sound applications.
I set the bed to 80c, and the hotend at 210c, with the help of Hairspray at the beginning.

*YOU MUST SCALE THESE DESIGNS BY 2540% BECAUSE I HAD TO DESIGN IN INCHES*

The largest print is less than 5 inches in diameter, and 5 inches tall, so it can fit on almost all print beds. The final speaker will be 5x5x7 inches!
.
This design has been designed to the exact volume requirements set out by the individual speakers. The frequency range of these speakers goes from an extreme bass of 80hz, all the way of to 40khz, defining it a High Fidelity Speaker. If you love sound, and would like to learn more about how it works, this set is for you.

It takes up low space on a desk or a bookshelf, and requires 16 hours of printing for the large piece, and 3 for the smaller one. The total filament used would be 250g, costing only $8.
.
A little bit of felt, around 1ft by 1ft, was stuffed behind the large s