Thingiverse
Decased SWIT Flow 2000 case
von Fincky
19
Downloads
11
Likes
0
Makes
Decased SWIT Flow 2000 RX case for FPV Cinelifting and other applications
Makes the RX half the weight of the original.
Print it in PLA.
For extra grip, add a piece of Ummagrip to the bottom flat part, glue spacer underneath the screw loop, use a 1/4 20 screw on the loop on the side to secure your RX to the top of the camera. Works perfect with RED Komodo and Sony FX6.
All you need to do is to decase the RX, add conformal coating (highly recommended), remove the barrel connector from the PCB and connect your connector of choice to that PCB.
Designed by Nicolas Gaillard
This work is under Creative Commons - NON COMMERCIAL, so no funny business ok?
Makes the RX half the weight of the original.
Print it in PLA.
For extra grip, add a piece of Ummagrip to the bottom flat part, glue spacer underneath the screw loop, use a 1/4 20 screw on the loop on the side to secure your RX to the top of the camera. Works perfect with RED Komodo and Sony FX6.
All you need to do is to decase the RX, add conformal coating (highly recommended), remove the barrel connector from the PCB and connect your connector of choice to that PCB.
Designed by Nicolas Gaillard
This work is under Creative Commons - NON COMMERCIAL, so no funny business ok?
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
