Decora Light Switch Cover

Cover plate for a decora light switch. If you have smart bulbs, cameras or other devices attached to a switch that you don't want accidentally turned off, then this is your solution. A quick and easy print that only requires 2 small round magnets (10x2mm). FeaturesFast and small print. Only 11g of filament and 23 minutes to print.No supportsRequires 2 magnets to attach to the light switchCustomizable magnet sizeNo glue. Magnets have a tight strong fit.Recessed magnet holes so the cover sits flat against the cover plate.InstructionsPrint the modelPlace a magnet on a flat sturdy surface and align the hole of the print and press down firmly until you feel the magnet go into the hole.Flip the print over so the magnet is visible. Take the back end of a screw driver or pen and press it in until it stops. It should be recessed about 0.5mm from the surface of the print. This ensures the cover sits flat on the light switch plate.I tried with smaller magnets 6x2mm and found they got easily k