Thingiverse
Decora Rack Mount for Rasperry Pi
door jake
125
Downloads
55
Likes
0
Makes
[Katascope's Quad Raspberry Pi Mount](https://www.thingiverse.com/thing:2006585) was designed for a HOSA PPP-000 19" inch rack panel. Unfortunately, this panel doesn't seem to be available anymore.
You can get, however a [quad Decora rack panel](http://www.ebay.com/itm/262972329313) that is very similar. As a bonus, you can also mount Decora outlets, switches, and keystone jack plates in the same panel. You can also get 1, 2 and 3 Decora panels, and ones that have [wire grommets as well](http://www.ebay.com/itm/262995447279).
My design includes holes for clear 1.75 t-glase to use as a light pipe, so you can see the LED indicators from the panel. Use a 1.75mm drill (or slightly smaller) to hone out the holes. The light pipe works okay (it's kind of dim, but you can see the lights). I use a longer length of the t-glase filament than needed and then pull through slowly as to not kink or bend the t-glase too much. Any bends or kinks really limit light transmission. Make sure t
You can get, however a [quad Decora rack panel](http://www.ebay.com/itm/262972329313) that is very similar. As a bonus, you can also mount Decora outlets, switches, and keystone jack plates in the same panel. You can also get 1, 2 and 3 Decora panels, and ones that have [wire grommets as well](http://www.ebay.com/itm/262995447279).
My design includes holes for clear 1.75 t-glase to use as a light pipe, so you can see the LED indicators from the panel. Use a 1.75mm drill (or slightly smaller) to hone out the holes. The light pipe works okay (it's kind of dim, but you can see the lights). I use a longer length of the t-glase filament than needed and then pull through slowly as to not kink or bend the t-glase too much. Any bends or kinks really limit light transmission. Make sure t
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
