Thingiverse
Decoy Detonator
por nimel
6
Descargas
20
Likes
0
Makes
This is a prop model of a decoy detonator as seen in Harry Potter and the Deathly Hallows Part 1.
Print one of each item, except for the Half_Ball and Half_Shaft. Each of those items must be printed twice. They were split in half for ease of printing.
Once all items are printed, assemble the pieces as shown in the picture, inserting the narrow end of the horn into one end of the bushing, and the narrow end of the now glued together ball into the other end of the bushing. Then, glue the two Half_Shaft pieces around the middle of the bushing. Glue the knob to the top of the glued together shaft and insert the bottom of the shaft into the hole in the top of the bell. Finally, glue the two feet to the bottom of the bell, making sure to balance the entire object so it will be able to stand upright on two feet.
Print one of each item, except for the Half_Ball and Half_Shaft. Each of those items must be printed twice. They were split in half for ease of printing.
Once all items are printed, assemble the pieces as shown in the picture, inserting the narrow end of the horn into one end of the bushing, and the narrow end of the now glued together ball into the other end of the bushing. Then, glue the two Half_Shaft pieces around the middle of the bushing. Glue the knob to the top of the glued together shaft and insert the bottom of the shaft into the hole in the top of the bell. Finally, glue the two feet to the bottom of the bell, making sure to balance the entire object so it will be able to stand upright on two feet.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
