Thingiverse
Deer-Scarer
door Facere
15
Downloads
23
Likes
0
Makes
Entirely inspired by http://www.thingiverse.com/thing:224441, but in less parts (3 STLs, print the peg twice).
Prints as base and arm and peg, sits nicely once pegs are glued.
Thing sits under tap/gentle stream/severed limb, fills slowly with liquid, until nearly full, then it tips forward, empties tapwater/fresh-foresty-water/blood, then the not-hollow-bit that sits below the peg once again is heavier, the arm resets.
Prints well with Ultimaker 2, sliced with Cura to be "hollow", aka criss-crossed lines, otherwise the lower arm may be too heavy for the hollow upper arm to outweigh once filled.
Prints as base and arm and peg, sits nicely once pegs are glued.
Thing sits under tap/gentle stream/severed limb, fills slowly with liquid, until nearly full, then it tips forward, empties tapwater/fresh-foresty-water/blood, then the not-hollow-bit that sits below the peg once again is heavier, the arm resets.
Prints well with Ultimaker 2, sliced with Cura to be "hollow", aka criss-crossed lines, otherwise the lower arm may be too heavy for the hollow upper arm to outweigh once filled.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
